martellmarine
Junior Member
Husband & wife team building boat #71.
Posts: 61
|
Post by martellmarine on Nov 6, 2020 19:22:26 GMT
I can see from the plans that the bunk/seat back rests and shelving can be made from 5-6mm plywood (at least that is the way that I read them). Presumably I can also use 5-6mm for shelving above nav station and galley. Was there anything else that can be made from 5-6mm stock? Did I read somewhere that the small 1/4 bulkheads dividing the space under the bunks can also be made from 6mm?
Cheers
|
|
|
|
Post by jimschofield on Nov 6, 2020 22:07:47 GMT
I can see from the plans that the bunk/seat back rests and shelving can be made from 5-6mm plywood (at least that is the way that I read them). Presumably I can also use 5-6mm for shelving above nav station and galley. Was there anything else that can be made from 5-6mm stock? Did I read somewhere that the small 1/4 bulkheads dividing the space under the bunks can also be made from 6mm? Cheers It looks like there are dividers under the bunks in this image from the page on specs.  And here is an option for over head lockers I just found online  Jim |
|
|
|
Post by Admin on Nov 7, 2020 21:12:45 GMT
you will see all our concept stuff on SPEC page of the website...You must use the Ply thickness specified on the plans for all those and similar components...so make sure your cabin sole is the right thickness and fitted..IE anyone with a stripped out boat at an official event with no cabin sole will not pass scrutiny...and you cannot lighten any specified ply...after that any extra fitout like our Galley shelves and Nav shelves are fine in 5/6mm..you can see we have gone solid specs on TREKKAS Builders blog shots...THNX
|
|
martellmarine
Junior Member
Husband & wife team building boat #71.
Posts: 61
|
Post by martellmarine on Nov 7, 2020 23:31:34 GMT
...You must use the Ply thickness specified on the plans for all those and similar components... Hi Don. The 4 x 1/4 bulkheads dividing the space under the bunks are not drawn on the plans. There is no thickness spec for them. So I am assuming 9mm? Thanks. |
|
|
|
Post by Admin on Nov 8, 2020 22:19:35 GMT
Hi....as they are not drawn it is up to you ....but yes it is a good idea to make them reasonable thickness....We used 8mm  on Trekka |
|
|
|
Post by Admin on Nov 8, 2020 22:19:54 GMT
Hi....as they are not drawn it is up to you ....but yes it is a good idea to make them reasonable thickness....We used 8mm on Trekka |
|
on Trekka